中国组织工程研究

中国组织工程研究 ›› 2012, Vol. 16 ›› Issue (4): 581-584.doi: 10.3969/j.issn.1673-8225.2012.04.002

• 数字化骨科 digital orthopedics • 上一篇    下一篇

有限元分析LISS-DF治疗股骨远端骨折近端螺钉单双皮质不同组合固定方式的应力分布*☆

张  岩1，杨铁毅1，刘树义1，王  治1，刘  粤1，龚璐璐2，丁祖泉2   

  1. 1上海市浦东新区公利医院骨科，上海市   200135；2同济大学生命科学与技术学院，上海市  200092
  • 收稿日期:2011-07-19 修回日期:2011-10-17 出版日期:2012-01-22 发布日期:2014-04-04
  • 通讯作者: 杨铁毅，主任医师，上海市浦东新区公利医院骨科，上海市 200135 yang.tieyi@yahoo.com.cn
  • 作者简介:张岩☆，男，1971年生，山东省泰安市人，汉族，2006年华中科技大学同济医学院毕业，博士，副主任医师，主要从事四肢创伤研究。 rmyyzh@126.com
  • 基金资助:

    上海市浦东新区卫生局重点学科资助项目(PWZxk2010-08)，课题名称：老年髋部骨折综合治疗模式的临床应用研究。

Stress distribution of proximal screw fixation of single and double cortex different combinations in less invasive stabilization system-distal femur treatment: A finite element analysis  

Zhang Yan1, Yang Tie-yi1, Liu Shu-yi1, Wang Zhi1, Liu Yue1, Gong Lu-lu2, Ding Zu-quan2   

  1. 1Department of Orthopedics, Gongli Hospital of Pudong New Area, Shanghai  200135, China; 2School of Life Science and Technology, Tongji University, Shanghai  200092, China
     
  • Received:2011-07-19 Revised:2011-10-17 Online:2012-01-22 Published:2014-04-04
  • Contact: Yang Tie-yi, Chief physician, Department of Orthopedics, Gongli Hospital of Pudong New Area, Shanghai 200135, China yang.tieyi@yahoo.com.cn
  • About author:Zhang Yan☆, Doctor, Associate chief physician, Department of Orthopedics, Gongli Hospital of Pudong New Area, Shanghai 200135, China rmyyzh@126.com
  • Supported by:

    Key Discipline Funding Project of Shanghai Municipal Pudong New Area Health Bureau, No. PWZxk2010-08*

PDF

504

摘要：

背景：如何确定LISS-DF近端螺钉单双皮质合理搭配的固定方式，以便达到骨折两端螺钉固定强度的相对平衡，降低锁定钢板、螺钉和骨皮质之间的剪切应力，避免螺钉的应力集中，产生更有效的治疗结果是避免内固定失败的关键。
目的：对LISS-DF钢板治疗股骨远端骨折近端螺钉单双皮质不同组合的固定方式进行有限元分析及力学评价。
方法：在ANSYS 9.0软件中建立LISS-DF钢板固定股骨远端骨折(AO/OTA33-A3型)的实体模型和有限元模型。在近端螺钉单、双皮质不同组合固定方式下，通过模拟生理应力做轴向加压、扭转实验，同时评估近端螺钉的应力变化。
结果与结论：在16种不同组合方式中，当近端螺钉组合为1，3单2，4双皮质固定时，近端4枚螺钉的应力均值最小为24.219 75 N，同时剪切应力均值亦为最小，位移变化与其他组合固定方式相当且均较小。提示近端螺钉靠近骨折端处双皮质固定，其余螺钉依次单双皮质交替固定时，LISS-DF系统应力分散，抗拔出和抗扭转效果好，从而减少钢板螺钉早期的松动脱落。
关键词：应力分布；LISS-DF；股骨远端骨折；内固定；有限元分析
doi:10.3969/j.issn.1673-8225.2012.04.002

关键词: 应力分布, LISS-DF, 股骨远端骨折, 内固定, 有限元分析

Abstract:

BACKGROUND: How to determine the less invasive stabilization system-distal femur (LISS-DF) proximal cortical screw fixation of single and double cortex in a reasonable collocation way to reach a relative balance of fixation strength in screw at both ends of fractures, decrease shear stress between the screws and cortical bone, avoid stress concentration of the screws, receive a better clinical effect. All of those are the key to prevent internal fixation failure.
OBJECTIVE: To observe the LISS-DF treatment of distal femoral fractures proximal cortex of different combinations of single and double screw fixation by finite element analysis and mechanical evaluation.
METHODS: Solid model and finite element model of the LISS-DF plate for distal femoral fractures (AO/OTA33-A3 type) were builded in ANSYS9.0 software. Proximal screws in single and double cortex fixation of different combinations, axial compression torsion test were detected through the simulation of physiological stress, and stress changes the proximal screw was evaluate.
RESULTS AND CONCLUSION: In 16 different combinations, when the combination of proximal screw 1, 3 single and 2, 4 double fixed cortex, mean stress of the proximal 4 screws was minimum (24.219 75 N), and the mean shear stress was also the minimum, displacement was close to other fixation and all were tiny. Proximal screw near the end of femoral fractures, and the remaining cortical screws followed by alternating single and double fixed, the LISS-DF system stress is decentralized, effect of anti-pull and anti-reverse is well, thereby the early loosening of plate and screw off is reduced.
 

中图分类号: